leg-150w seriesC fixed output and dimmable switch mode led drivers constant current, non-isolated black magic thermal advantage? metallic housing electrical specifcations input voltage range: 120-277 vac nom. (108-305 v min/max) input over-voltage: can endure 320vac for 48 hrs, 350vac for 2 hrs frequency: 50/60 hz nom. (47-63 hz min/max) power factor: >0.90 @ full load, 100v through 277v thd: <_ 20% @ for all loads >80% inrush current: <40.0 amps maximum @ 230 vac, cold start 25oc input current: 1.4a@ 120vac, 0.68a @ 230vac maximum power: 150w current accuracy: 1% over input line variation load regulation: 2% leakage current: 400 ua typical hold up time: half cycle protection: output protection: over-voltage, over-current, and short circuit protection, reset by power cycling environmental specifcations minimum starting temp: -30oc maximum case temp. 80c storage temperature: -40oc to +85oc humidity: 5% to 95% cooling: convection vibration frequency: 5 to 55 hz/2g, 30 minutes sound rating: class a mtbf: 380,000 hours at full load and 40oc ambient conditions per mil-217f notice 2 emc: fcc 47cfr part 15 class a compliant impact resistance: 1g/s weight: 45 oz (1270 grams) constant current - non dimming model number output voltage range (vdc) output current (ma 3%) max output power (w) max effciency leg150w-425-c0350 120-425 350 148.7 92% leg150w-280-c0530 94-280 530 148.4 91% leg150w-210-c0700 70- 210 700 147.0 90% constant current - 0-10vdc dimming model number output voltage range (vdc) output current (ma 3%) max output power (w) max effciency leg150w-425-c0350-d 120-425 350 148.7 92% LEG150W-280-C0530-D 94-280 530 148.4 91% leg150w-210-c0700-d 70-210 700 147.0 90% e332160 sign components manual ordering options: -d: 0-10v & resistance dimmable version comes with an extra two wires +purple/-gray on the output side. 0-10v dimming is compatible with most quality 0-10v dimmers. see pg. 3 for more information. ? total power: 75 watts ? input voltage: 100-277 vac nom. ? ul dry & damp location rated ? ip66 ? high power factor ? ul8750, en61347, csa 22.2 rev 8-31-15 specifcations subject to change without notice. note: led drivers are designed and intended to operate led loads only. non-led loading may be outside the specifed design limits of our led drivers, and therefore cannot be covered by any warranty. if you desire to use our led drivers to operate non-led loads please contact us to discuss compatibility. thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com
pg 2 of 3 dimensions - inches (mm) case must be grounded in end use application output red (+) blue (-) input white (n) black (l) dimming purple (+) gray (-) wire specs: ac input / dc output / dimming control: ? solid copper ? 8 in [203mm] ? ul1316/1452 #18awg tc = 80c max ul conditions of acceptability see website for additional information 40 case hotspot temperature (c) lifetime (khrs) lifetime/case temperature (full load @ 120vac) 0 25 75 100 250 200 150 125 275 225 175 50 300 45 50 55 60 65 70 75 80 leg150w series note: life calculations are based on reliability with confdence using a 90% confdence level and <5% failure rate. at a confdence level of 90% it is expected that <5% of the parts will fail at the rated life provided. (failure is defned as a driver drifting outside specifcation, rather than fail to operate) thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
pg 3 of 3 parameters minimum typical maximum source current out of 0-10v purple wire 0 ma 2 ma absolute voltage range on 0-10v (+) purple wire -2.0 v +15 v dim (+) purple ip710 wall dimmer leg150w-xx-cxxxx-d dim (-) gray (dimmer must be current-sink type control) typical dimming circuit 0v 1v 2v 3v 4v 5v 6v 7v 8v 9v 10v d i mmi n g i n p u t ( v dc) o u t put c u rre n t / 0 - 1 0 v dc d i mmi ng i nput 0 1 0 2 0 3 0 4 0 5 0 6 0 7 0 8 0 9 0 100 outpu t cu rr ent % -d option: - 0-10vdc and resistance dimming notes: 1. 0-10v dimmable version comes with an extra two wires +purple/-gray on the output side. 2. when connected to a dimming device, 0-10v dimmable version will have a 10% output current tolerance. this is due to variation between different 0-10v dimmers. 3. compatible with most 0-10v wall slide dimmers and direct 0-10v analog signal. recommended dimmer is leviton ip710 or equivalent 4. 0-10v dimmable version is not intended to dim below about 5% @ 0v or 10% @ 1.0v 5. 0-10v dimmable version output will be 100% with purple/gray open and minimum with purple/gray shorted. leg150w series thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
|
